Troubleshooting - Epson TM-U230 Bedienungsanleitung

Installing the Ribbon
CAUTION:
Be sure not to touch the manual cutter. Otherwise your fingers might be
injured.
Use the EPSON ERC-38. The use of any ribbon cassettes other than
those approved by EPSON may damage the printer and will void
the warranty.
1. Turn on the printer. Turn the knob on the ribbon cassette.
2. Open the paper roll cover and cutter cover.
3. Lift the autocutter, using the tab; then insert the new ribbon.
4. Turn the knob 2 or 3 times again and check if the ribbon
cassette is in the right position.

Troubleshooting

Error light on or blinking.
❏ Check to see that the paper roll and cutter covers are closed,
and check the PAPER OUT light. Replace the paper when
necessary.
❏ If the paper is jammed, remove the jammed paper, following
the paper jam description below.
❏ Turn off the printer for a few seconds and then turn it back on.
If the light is still blinking, call your supervisor or a service
person.
tab
TM-U230 User's Manual 7
English