Epson TM-U230 Bedienungsanleitung Seite 10

English
Paper jam.
Print head is hot.
1. Turn off the printer, open the paper roll cover and cutter cover;
then lift the autocutter, using the tab.
2. Cut the paper off behind the paper insert slot and remove the
paper roll from the printer.
3. Remove the jammed paper by pulling it in the paper feed
direction. Always pull the paper in the paper feed direction to
prevent damage to the printer mechanism.
4. If paper still remains in the printer, remove the ribbon cassette.
5. Loosen the screw securing the print head cover. Turn the screw
only until you can tilt it as shown in the illustration below.
Note:
Do not remove the screw from the print head cover.
6. Lift up the print head cover; then remove the jammed paper.
7. Replace the print head cover and secure it with the screw.
8. Replace the ribbon cassette and close the autocutter.
Note:
Choose an installation place so that fed paper does not accumulate.
Otherwise a paper jam might occur.
8 TM-U230 User's Manual
CAUTION:
screw
print head cover