Throttle Hold; Stunt Mode - Blade BLH3380 Bedienungsanleitung

Throttle Hold

Throttle hold is used to turn off the helicopter motors if the helicopter is out of control, in danger of crashing or
both. Activate throttle hold anytime the helicopter is in danger to reduce the chance of damaging the helicopter
in a crash. Throttle hold will stop the motor in normal or stunt mode.
1.
1.

Stunt Mode

Stunt Mode allows the helicopter to fl y inverted and perform aerobatics. The throttle runs continuously when Stunt Mode
is ON, regardless of throttle stick position. Turn Stunt Mode OFF to return control to the throttle stick.
Use the AUX/ACT switch on the DX4e transmitter or Gear switch on the DX5e transmitter to activate Stunt Mode.
DX4e – AUX/ACT OFF – Normal Mode
AUX/ACT ON – Stunt Mode
Throttle Hold ON (DX4e)
Press the trainer button anytime to turn throttle hold ON after connecting the
battery to the helicopter. The blue LED fl ashes, indicating throttle hold is ON.
Throttle Hold OFF (DX4e)
1. Make sure the AUX switch is in the OFF position.
2. Lower the throttle stick.
3. Press the trainer button three times within 3 seconds. The blue LED is solid.
2.
Throttle Hold ON (DX5e)
Pull the trainer switch anytime to turn throttle hold ON after connecting the
battery to the helicopter. The blue LED fl ashes, indicating throttle hold is ON.
Throttle Hold OFF (DX5e)
1. Make sure the Gear switch is in the (0) position.
2. Lower the throttle stick.
3. Pull the trainer switch three times within 3 seconds. The blue LED is solid.
2.
DX5e – Ch 5 (0) – Normal Mode
DX5e – Ch 5 (1) – Stunt Mode
9
3.
X3
3.
X3
EN