As3X Flybarless Helicopter Technology; First Flight Preparation; Flying Checklist; Programming Your Transmitter - Blade BLH3380 Bedienungsanleitung

AS3X Flybarless Helicopter Technology

®
The Blade Nano CP X features on-board AS3X fl ybar-
®
less technology. AS3X technology combines 3-axis gyro
stabilization with a new fl ybarless colective pitch rotor
head, resulting in less drag, fewer parts and increased
performance.

First Flight Preparation

• Remove and inspect contents
• Charge the fl ight battery
• Install the four AA batteries in the transmitter
(RTF ONLY)
• Install the fully charged fl ight battery in the helicopter
• Program your computer transmitter (BNF ONLY)
• Test the controls
• Familiarize yourself with the controls
• Find a suitable area for fl ying
Programming Your Transmitter (Computer Transmitters Only)
Program your transmitter before attempting to bind or fl y the helicopter. If the throttle and pitch programming
values are incorrect, the helicopter will not respond. Transmitter programming values are shown below for the
TM
Spektrum DX6i, DX7, DX7s, DX8, and DX18. The Spektrum DX8, DX7s, and DX18 model fi les are also available for
download online at the Spektrum DX8 Community.
NOTICE: When using a Futaba
and rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba
transmitter manual for instructions on reversing the throttle channel.
DX6i
SETUP LIST
Model Type
HELI
Reverse
THRO N
AILE N
ELEV N
RUDD N
GYRO N
PITC R
Swash Type
1 Servo 90
Timer
4:00
®
transmitter with a Spektrum DSM module, you must reverse the throttle channel
ADJUST LIST
D/R & Expo
0-AILE 100% 30%
0-ELEV 100% 30%
0-RUDD 100% INH
1-AILE 85% 30%
1-ELEV 85% 30%
1-RUDD 85% INH
Travel Adj
THRO 100%
AILE 100%
ELEV 100%
RUDD 100%
GYRO 100%
PITC 100%
5
The AS3X technology also improves tracking, stability and
cyclic response for intermediate and advanced pilots.
However, the AS3X fl ybarless system is not a fl ying aid for
beginners.

Flying Checklist

❏ Always turn the transmitter on fi rst
❏ Plug the fl ight battery into the lead of the
3-in-1 control unit
❏ Allow the 3-in-1 control unit to initialize and
arm properly
❏ Fly the model
❏ Land the model
❏ Unplug the fl ight battery from the 3-in-1 control unit
❏ Always turn the transmitter off last
Thro Curve
NORM 0% 40% 60%
STUNT 100% 100% 100% 100% 100%
HOLD 10% 10% 10%
Pitc Curve
NORM 30% 40% 50%
STUNT 0% 25% 50%
HOLD 0% 25% 50%
80% 100%
10% 10%
75% 100%
75% 100%
75% 100%
EN
®