Worx Landroid M Installationsanleitung Seite 16

4. Turn on and test the installation
This is the exciting part where you can turn your Landroid
4.2
Open the panel cover, press
power button,
then input the default PIN
Press the key and close
the control panel cover: your
16
Landroid M will now
®
find its way to the charging base.
EN
09:00pm 09:00pm
Watch the Landroid Wed. 6-8-2012
Wed. 6-8-2012
M T W T F S S M T W T F
7:00am ~ 12:00am
7:00am ~ 12:00am
it returns to the charging
base and modify the
positioning of the boundary
wire if necessary. When the
Landroid M successfully
®
returns to the charging base,
this means the installation has
been successfully completed!
Now your Landroid
start to fully charge.
• If your Landroid
is outside its territory,
it will not move and
Warning
the display will indicate
"outside working area"
error. Just move it inside
its territory and repeat
step 4.2
NOTE: Please refer to the Programming and Troubleshooting Guide for more information.
0000.
09:00pm
M as
® Wed. 6-8-2012
S S M T W T F S S
7:00am ~ 12:00am
M will
®
M • If your Landroid
®
inside its territory but
the display says "outside
working area" and the
LED is on, it means you
clamped the boundary
wire ends incorrectly.
Just reverse them.
M on for the first time.
®
4.1
Place your Landroid
working area, a few meters from
the back of the charging base.
09:00pm
Wed. 6-8-2012
M T W T F S S
7:00am ~ 12:00am
M is • Your Landroid
®
should always remain
switched on. If you ever
need to turn it off, then
make sure you place it
within its boundary area
before you switch it back
on again.
M inside the
®
09:00pm
09:00pm
Wed. 6-8-2012
Wed. 6-8-2012
M T W T F S S
M T W T F S S
7:00am ~ 12:00am
7:00am ~ 12:00am
M • Should your
®
Landroid M stop
®
operating unexpectedly,
just press its ON/OFF
key to ON, correct the
problems, press Start
button and close the
cover.