Preparation Of Ice Cubes; Ice Pack; Defrosting - AEG ARCTIS 70220 GS Gebrauchsanweisung

Preparation of Ice Cubes

1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer com-
partment and leave to freeze.
2. To loosen the frozen cubes, either bend the ice cube tray or hold it under
running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer com-
partment using pointed or sharp edged objects. Use the ice scraper supplied.

Ice pack

There are two ice packs in one drawer of the freezer.
In the event of a power failure or malfunction, the ice packs will lengthen
the amount of time it takes for the frozen food to become too warm by
several hours. The ice packs can only fulfil this task optimally if it is placed
in the uppermost drawer, at the front, above the frozen food. You can use
the ice packs for cooling cold bags.

Defrosting

The freezer however, will become progressively covered with frost. This
should be removed with the special plastic scraper provided, whenever the
thickness of the frost exceeds 4 mm. During this operation it is not neces-
sary to switch off the power supply or to remove the foodstuffs.
However when the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
1. Remove the frozen food from the
freezer, wrap it in several layers of
newspaper and put it in a very
cool place.
2. Switch off the appliance and pull
out the plug, or press the
"ON/OFF" button
3. Leave the freezer compartment
door open.
4. Insert the plastic scraper into the
recess provided under the defrost
water channel and place a collec-
ting basin under it.
5. Once defrosting is completed keep the scraper for future use;
D068
51