Electrical Connection - AEG ARCTIS 70220 GS Gebrauchsanweisung

5. Refit the door.
6 With a wrench of 10 mm unscrew
the pivot pin (z) of the hinge (e)
and the rear screw (y); take from
the accessory bag the lower clo-
sing device left (m) and refit on
opposite side of the same hinge
by rescrewing the rear screw. Take
from the accessory bag the upper
closing device (n) and refit on the
opposite side of the upper trim
rescrewing the screw.
7. Refit bottom hinge (E) on the
opposite side, using the two
screws previously removed inser-
ting the hinge gasket (x).
8. Remove blanking cover (F) from
ventilation grille (D) by pushing it
in the direction of the arrow and
refit it on the opposite side.
9. Refit ventilation grille (D), clip-
ping it into place.
10. Unscrew the handle. Refit it on opposite side after having pierced the plugs
with a punch. Cover the holes left open with the plugs contained in the
documentation pack.
Attention:
After having reversed the opening direction of the doors check that all the
screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
46
AC 220 ... 240 V
220 ... 240 V~ 50 Hz
50 Hz or
G