Herunterladen Inhalt Inhalt Diese Seite drucken

What's In The Box; Tools And Supplies; Disconnecting The Battery; Replacing The Fuse - MAC Audio MAC 420 Installationsanleitung

Vorschau ausblenden Andere Handbücher für MAC 420:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

What's in the Box

• MAC 420 Head Unit
• Left and Right Double DIN Mounting Brackets
• Double DIN Half Sleeve Install Bracket
• Custom Cosmetic Trim Ring
• Hardware Bag
• Power / Speaker Harness with ISO connectors
• A/V Input/Output Harness
• External Microphone
• Remote Control
• Owner's Manual
• Installation Guide

Disconnecting the Battery

To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to
installation.

Replacing the Fuse

The fuse is located below the receptacle for the Power / Speaker Harness. When replacing the fuse, use a new 15A
replacement fuse. Using a fuse with an improper rating could damage the unit and cause a fre.
ISO-DIN Installation
This unit is designed to ft into a 2.0 DIN
dashboard opening, found in many impor-
ted cars. The unit has threaded holes in the
chassis side panels which may be used with
the original factory mounting brackets of some
Toyota, Nissan, Mitsubishi, Isuzu, Hyundai
and Honda vehicles to mount the radio to the
dashboard. Please consult with your local car
stereo specialty shop for assistance on this
type of installation.
1. Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they will
be used to mount the new radio.
2. Remove the factory mounting brackets and
hardware from the existing radio and attach
them to the new radio.
CAUTION! Do not exceed M5 X 6MM
screw size. Longer screws may damage
components inside the chassis.
WARNING! Never install this unit where operation and viewing could interfere with safe driving conditions.

Tools and Supplies

You will need these tools and supplies for installation:
• Torx type, fat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screw driver, socket
wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
5 5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis