Atag SX 111 M Bedienungsanleitung Seite 28

safety
what you should pay attention to
general
Always fill the reservoir with water before starting to steam
cook.
Do not use distilled water. It is not suitable for consumption.
Remove the accessories from the steam oven and clean it
with a mild cleaning agent.
For safety tips in Repairs must only be carried out by an authorised service
engineer.
relation to the
installation, we refer
Never open the appliance's casing and do not alter the
you to the
mechanical and/or electrical structure of the appliance. This
instructions in the
accompanying could result in dangerous situations (touching live
installation guide. components) and faults.
Do not use the appliance if it is damaged.
The appliance should be disconnected from the mains before
being repaired or cleaned. Remove the plug from the socket
or turn the switch in the meter cupboard to zero.
For electrical safety reasons, the appliance must not be
cleaned using high-pressure cleaners or steam cleaners.
This steam oven has been designed for domestic use. You
should only use it for cooking food and warming plates.
GB 4
introduction
The steam oven has two functions: steam cooking and
warming plates. You can also set the cooking time. This page
and the following ones tell you how to use the steam- and
plate-warming functions.
filling the water reservoir
1 Take the water reservoir out of the steam oven.
2 Fill it with water up to the maximum level.
3 Slide the water reservoir back into the oven.
tip
removing the water
In areas with very hard water, it is best to use bottled water.
reservoir
maximum level
level indicator
The amount of water in the reservoir is shown in the display.
When the 'empty jug' symbol blinks, the reservoir is empty.
A sound signal is heard. The door can be opened.
half full
If you remove the jug, the sound signal stops.
Fill the water reservoir and put it back.
When the door is closed, the steam cooking is resumed.
nearly empty
empty
operation
preparation
GB 5