Switching The Light On/Off; Grease Filter Signal; Charcoal Filter Signal - Pelgrim CMV680ERVS Anleitung

OPERATION

Switching the light on/off

Grease filter signal

Charcoal filter signal

GB 10
▷ If you press the timer button with the hood in setting 3, the hood
will switch off after 10 minutes.
▷ If you press the timer button with the hood in setting 4, the hood
will switch off after 5 minutes.
If the switch-off time has been set, a dot will blink in the display.
• You can switch off the hood completely during the switch-off time
by pressing the On/Off button or the timer button.
• If you press the fan button during the switch-off time, the hood
keeps active and will not switch off automatically.
• Press the light button.
The lighting comes on.
• Press the light button again.
The lighting goes off.
• The grease filter signal occurs after 40 hours of operation and is
shown in the display with number 1 flashing. Such signal means
that the grease filter needs to be cleaned. The signal is visible when
the hood is ON. On page 12 and 13 you can read how to clean
the grease filters. Have you replaced the grease filters, you can
deactivate the grease filter signal by pressing the On/Off button for
at least three seconds, until it goes off.
▷ If the charcoal filter has to be cleaned also, numbers 1 and 2
flash alternately in the display. To reset, carry out the procedure
to deactivate the signal twice.
• The charcoal filter signal occurs after 320 hours of operation and
is shown in the display with number 2 flashing. Such signal means
that the charcoal filter needs to be cleaned. The signal is visible
when the hood is ON. On page 13 and 14 you can read how to
clean the charcoal filter. Have you replaced the charcoal filter, you
can deactivate the charcoal filter signal by pressing the On/Off
button for at least three seconds, until it switches off.
▷ If the grease filters have to be cleaned too, numbers 1 and 2
flash alternately in the display. To reset, carry out the procedure
to deactivate the signal twice.