Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Attach the lid by turning it clockwise and applying pressure
at the same time.
Installation of accessories
NOTE:
Observe the arrow markings on both the appliance and ac-
cessories.
1. Insert the locking catches of the hose as far as they will go
into the connecting tip of the appliance. Secure the hose by
turning it clockwise.
2. Insert the locking catches of one of the attachments as far
as they will go into the connecting tip of the hose. Secure
the attachment by turning it clockwise.
•
You may also connect the attachments directly to the appli-
ance. Connect as described above.
•
Attach the angled nozzle or the circular brush on top of the
nozzle adapter, if required.
•
In order to clean sensitive surfaces, attach the fleece cloth
to the cleaning attachment.
•
In order to use the window cleaning attachment, hook it into
the cleaning attachment (without the fleece cloth).
Electrical Connection
•
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
•
Connect the device to a duly installed protective contact
socket.
WARNING:
• Always remove the mains plug before cleaning the device.
• Under no circumstances should you immerse the device in water
for cleaning purposes. Otherwise this might result in an electric
shock or fire.
CAUTION:
•
Do not use a wire brush or any abrasive items.
•
Do not use any acidic or abrasive detergents.
•
Before the device is put away or cleaned it must have
completely cooled down.
•
Clean the appliance and accessories with a slightly damp
cloth.
CAUTION:
Before you begin cleaning you should test the materials to
be cleaned as to their suitability for cleaning with steam. Do
not hold the steam nozzle for too long and too close in one
position.
•
When the plug is connected to a wall socket, the water in
the boiler starts heating up. The heating control lamp lights
up.
•
Pressure starts building up in the boiler after approx.
3-4 minutes. When the appliance is ready for use, the
control lamp turns off.
•
Press the steam button to generate steam.
NOTE:
Using the appliance with the maximum water amount and in
continuous operation will allow for steam generation of up to
8 minutes.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be filled up as follows:
1. Remove the mains plug from the socket!
2. Fill fresh water into the tank as described in the chapter "Fill
in Water" (steps 1-6).
3. Connect the mains plug to the wall socket to continue
operation.
When you have finished using the device
1. Remove the mains plug from the socket!
2. Let the unit cool down completely.
3. Empty the water tank.
Cleaning
•
The fleece cloth can be machine-washed at 60°C. Do not
dry in a tumble dryer.
•
Regularly remove lime deposit from the boiler in order to
ensure a long service life for the appliance. When doing so,
use clean water without any additives.
Using the Device
27
Werbung
Inhaltsverzeichnis
