Unpacking The Device; Initial Operation; Using The Device - BOMANN DR 907 CB Bedienungsanleitung

Unpacking the Device

• Remove the main device and accessories from the box.
• Also remove any packaging materials that may be
present.
• Check the scope of delivery.

Initial Operation

Fill in Water
NOTE:
• The maximum filling capacity is approx. 250 ml. Use the
measuring cup provided.
• Recommendation: Use distilled water to prevent
calcification.
CAUTION:
Do not use battery water, water from tumble dryers or water
with additives such as cleaning agents, alcohol, fabric
softener or other chemicals. They could cause hazards or
damage to the appliance.
WARNING: Risk of injury!
1. Disconnect the mains plug from the wall socket.
2. The appliance can be opened only when the pressure
has been relieved. Unlock the lock by pushing it to ON
and holding it there. Then press down the steam button.
3. If the appliance is still warm, wait approx. 5 minutes until
removing the lid.
4. Unscrew the lid anticlockwise to remove it.
5. Pour any remaining water from the boiler in order to avoid
overfilling.
6. Use the funnel to fill the boiler with a maximum of approx.
250 ml of water.
7. Attach the lid again by turning it clockwise.
Installation of Accessories
NOTE:
Observe the arrow markings on both the appliance and
accessories.
1. Insert the locking catches of the hose as far as they will
go into the connecting tip of the appliance. Secure the
hose by turning it clockwise.
2. Insert the locking catches of one of the attachments as far
as they will go into the connecting tip of the hose. Secure
the attachment by turning it clockwise.
• You may also connect the attachments directly to the
appliance. Connect as described above.
• Attach the angled nozzle or the circular brush on top of the
nozzle adapter, if required.
DR907CB_IM
• In order to clean sensitive surfaces, attach the fleece cloth
to the cleaning attachment.
• In order to use the window cleaning attachment, hook it
into the cleaning attachment (without the fleece cloth).
Electrical Connection
1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device
You can find this information on the nameplate.
2. Connect the device to a duly installed protective contact
socket.

Using the Device

WARNING: Risk of scalding!
Keep the device straight. Tilting the device by more than
45 ° can cause hot water to leak from the device.
CAUTION:
Before you begin cleaning you should test the materials to
be cleaned as to their suitability for cleaning with steam.
Do not hold the steam nozzle for too long and too close in
one position.
• When the plug is connected to a wall socket, the water
in the boiler starts heating up. The heating control lamp
lights up.
• Pressure starts building up in the boiler after approx.
3 ­ 4 minutes. When the appliance is ready for use, the
control lamp turns off.
• Unlock the lock by pushing it to ON and holding it there.
Then press down the steam button to generate pressure.
NOTE:
Using the appliance with the maximum water amount and
in continuous operation will allow for steam generation of
up to 10 minutes.
Filling the Water Tank during Operation
No steam will be discharged if the water tank is empty. The
water has to be filled up as follows:
1. Remove the mains plug from the socket!
2. Fill fresh water into the tank as described in the chapter
"Fill in Water" (steps 1 ­ 7).
3. Connect the mains plug to the wall socket to continue
operation.
When you have finished using the Device
1. Remove the mains plug from the socket!
2. Let the unit cool down completely.
3. Empty the water tank.
27
18.10.16