Epson TM-U950 Bedienungsanleitung Seite 9

CAUTION:
To prevent paper jams, be sure both paper rolls are installed.
Do not insert checks with staples in them; do not insert wrinkled checks.
1. The SLIP light flashes.
2. Insert the check face down, with the
MICR characters on the right-hand
side.
3. Insert the check straight into the inlet,
using the right edge of the inlet as a
guide, as far as the check will go. See
illustration
4. The printer starts drawing the check
in. Let go of the check immediately.
The SLIP LED goes from blinking to on.
5. When MICR reading is complete, the printer ejects the check
and the SLIP LED starts blinking again.
6. Remove the check by pulling it straight out (not at an angle).
The SLIP LED goes off.
Cleaning the Optional MICR Mechanism
Clean the MICR head and MICR roller every 6000 passes or once a
month.
Note:
If you encounter frequent MICR reading errors, use the procedure below.
For the MICR head
Use a moistened cleaning sheet, such as PRESAT brand (KIC) "Check
Reader Cleaning Card" or an equivalent commercially available
cleaning sheet.
For the MICR feed roller
Use an adhesive cleaning sheet available from Epson. Contact your
dealer.
Cleaning procedure
Use this procedure for both cleaning sheets.
1. Load both paper rolls into the printer; then turn off the power.
2. Open the front cover and turn the power back on while holding
down the JOURNAL/SLIP button.
3. Press the JOURNAL/SLIP button 3 times.
4. Close the front cover (the SLIP LED flashes).
.
9
9
✍
①
TM-U950 User's Manual 7
English