Hoval HSP 15/6 Einbau- Und Betriebsanleitung Seite 30

English
NOTE: If a standard heating pump is replaced by this high-
efficiency pump, the knob can be set (as a reference point
for setting the pump setpoint) on the first, second or third
increment on the scale for ∆p-c.
Setting of the delivery head
When the knob is turned, the LED display changes to the
set pump setpoint. The "m" symbol lights up. If the knob is
turned from the middle position to the left or to the right, the
set setpoint for the respective control mode is increased. If
the knob is turned back again to the middle position, the set
setpoint is reduced. The setting can be carried out in 0.1 m
steps.
If the knob has not been turned for a duration of 2 seconds,
the display changes back to the current power consumption
after flashing five times. The "m" symbol no longer lights up.
Factory setting: ∆p-v, ½ H
NOTE: All settings and displays are retained if the mains
supply is interrupted.
6 Maintenance/faults
DANGER: Before starting any maintenance and repair
work, disconnect the pump from the power supply, and
make sure it cannot be switched back on by unauthor-
ised persons.Damage to the connection cable should
always be repaired by a qualified electrician. Have faults
remedied by qualified skilled personnel only!
24
max
4210591-Ed.01 (2016/03)