Intended Use; Technical Data; Important Safety Instructions; Assembly - Nilfisk-ALTO Why Compromise Floortec 380 M Betriebsanleitung

FLOORTEC 380 M
english

1.1.1 Intended Use

1.2

Technical Data

2 Operation
2.1 Important Safety
Instructions
2.2

Assembly

2.2.1 Fitting of the handle

4
This machine is designed only
for sweeping on solid, level
floors.
Any other form of use is regard-
ed as contrary to its intended
use. The manufacturer will ac-
cept no liability for any damage
or injury resulting from such
forms of use.
Working width with side brushes ....mm ......................................800
Working width of main brushes ......mm ......................................470
Dirt collecting tank capacity............l..............................................40
Sweeping capacity..........................m²/h ............................. ca. 3500
Overall width...................................mm ......................................650
Overall height with/without handle..mm .............................330/1000
Weight ............................................kg...........................................12
Do not sweep up burning or
smouldering objects, e.g. ciga-
rettes, matches or similar objects.
When removing any glass, met-
al or similar materials from the
dirt collecting tank, wear sturdy
gloves to avoid the risk of injury.
The dirt collecting tank should
be emptied after every use
of the sweeping machine.
The sweeping machine is not
For packaging reasons, the
sweeping machine is delivered
in only partially assembled
state.
Unauthorised modifications to
the machine also relieve the
manu facturer of any liability
for resulting damage or injury.
The brush sweeping
chine is not suitable for use
in sweeping up inflammable,
explosive, toxic, carcinogenic
or any other form of health
endangering substances and
materials.
suitable for use with liquids.
Do not use the sweeping
machine in the immediate
vicinity of heat sources (fire,
radiators, heater fans or simi-
lar heat radiating equipment).
Use only original Alto accesso-
ries and spare parts.
The handle and side brushes
must be fitted.
• Unpack the machine and
place it on a level surface.
• Hold the handle in the nor-
mal sweeping position and
then push it downwards and
forward until it bottoms.
• Tighten the two retaining
knobs securely.
ma-