Contact Information - Eufab 16505 Bedienungsanleitung

Connecting the battery maintenance device
Caution: Ensure that the battery maintenance device is not connected to the power socket. Always
connect the red positive cable (+) of the charger to the positive pole of the battery first. Then connect the
black minus-cable (-) to the minus pole of the battery. If you charge the battery in situ, connect the black negative
cable (-) to the car body, far away from the battery, the carburettor and fuel lines. Always stick to this sequence.
Protection from connection to the wrong pole
This device is protected against accidental incorrect connection. If the pole clamps are connected incorrectly and
the power supply plugged in, the control LEDs will not light up.
Charging of battery
Now, connect the power supply of the battery maintenance device to the main socket. The charging process is now
started and the control LEDs „CHARGING" and „POWER" light up.
The charger determines when the battery voltage has reached a value of 13.5 Volts. It ends the charging process and
switches over to maintenance charge (the green „CHARGING" LED flashes). When the measured value is 13 Volts, the
charging process is started again.
Finish the charging process by disconnect the power supply of the battery maintenance device from the mains
socket.
Removing the charger
Caution: First pull the plug out of the socket and observe the following sequence for disconnection. This
prevent the generation of sparks. Since charging generates a detonating gas, this is particularly important
for the sake of your safety.
Separate the battery maintenance device from the supply network.
Then, remove the connection of the black clamp (-). Now, remove the battery clamp from the positive pole (+)
of the battery.
Maintenance and care
Maintenance If used correctly, the device is maintenance-free.
Care Clean the pole callipers every time the charging procedure is completed. Carefully clean the device with a dry
cloth. Do not use liquids or chemical cleaning agents. Never submerge the device in liquids. Never allow liquid to
flow over the device.
Properly roll up the cable before storing the device to prevent damage to the cables and the device. Store the device
in a dry and clean location.
Notes regarding environmental protection
Do not put electrical devices into the household waste! Electronic and electrical devices must be collected
separately and sent for environmentally friendly recycling. Please contact your community or city
administration regarding disposal options for electronic scrap.

Contact information

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
Telephone: +49 (0)202 42 92 83 0 Fax: +49 (0)202 2 65 57 98
Internet: www.eal-vertrieb.de
6
Email: info@eal-vertrieb.com