Explanation Of Symbols; Safety Notes - Eufab 16505 Bedienungsanleitung

Explanation of symbols

Safety notes

The warning triangle labels all instructions important to safety. Always follow these otherwise you could injure
yourself or damage the device.
Only connect the device to a power socket installed according to regulations. The voltage must correspond
to the specification on the type plate of the device.
Do not trap the power cable and protect it from sharp edges, damp, heat or oil. The power cable of the unit
cannot be replaced. In the event that the cable is damaged, the unit must be disposed of.
Do not operate the device or immediately pull the plug if it is damaged or you suspect it may be defective.
In this case, contact our technicians.
Pull the plug when the device is not in use.
Keep packaging materials, especially plastic and plastic bags, away from children. Risk of suffocation.
Remove all plastic from the device before use.
Place the mains cable in such a manner that it does not impede and that it cannot be unplugged accidentally.
Disconnect the battery charger from the power supply after the charging process.
Keep the charger in a place that cannot be accessed by children or unauthorised persons.
Never operate the device in the vicinity of flammable materials or in an environment prone to explosion.
Do not cover the charger as this may lead to overheating and thus damage to the device. Never set the
charger up for operation on a surface that is insulating (e.g. polystyrene). There is a risk of heat built up!
If you wish to charge a vehicle battery in the installed state, first park the vehicle safely, put on the parking
break and switch off the ignition. Cut the battery off from the on-board network of your vehicle. To do this,
consult the manual for your vehicle, or ask your specialist workshop.
Only hold the power supply at the power plug when disconnecting from the power socket.
Do not expose the charger to fire, heat and long-exposures to temperatures in excess of +40°C!
Store these instructions carefully and, if necessary, pass them on to other users.
Operating instructions
Preparation of the battery
Clean the battery poles from dust and corrosion residue. In case of maintenance-free batteries, please follow the
instructions of the battery manufacturer to the letter.
5