Motor Protection (Overload); Cleaning; Maintenance - rotor 1125.001 Bedienungsanleitung

© Rotor Lips AG

8. MOTOR PROTECTION (OVERLOAD)

When the machine is overloaded or overheated, it switches off
automatically.
If this occurs, after about 60 seconds press the black button
on the bottom plate of the motor base.
If you notice any irregularities or defects, please contact your
supplier. For more information see chapter „Repairs".

9. CLEANING

The motor unit must never be submerged in, or sprayed with water or any other
liquid! Never attempt to clean it with a water jet!
If necessary, clean the motor unit with a damp cloth.
Container: The mixing container should not be cleaned in the dishwasher while still
installed. They must first be dismantled.
The container should be cleaned thoroughly after each use or once a day.
Bowl: Can be cleaned in the dishwasher or clean by hand using hot water and a
commercial cleaning product.
Cutter assembly: simply rinse and, if necessary, scrub off. Never place
into water or the dishwasher.
Threaded ring: should be cleaned especially inside, by using a hard brush.

10. MAINTENANCE

The motor bearings are permanently lubricated and therefore require no maintenance.
16
Instruction Manual
Rotor Bar Blender
CH-3661 Uetendorf