Care And Cleaning; Case Front; Remove The Oven Door - Comfee CHK65E Benutzerhandbuch

Care and cleaning

Care and cleaning
!
• For cleaning, don't use steam cleaners.
• Before cleaning the machine, let it cool down and un-
plug from the mains.
• Don't use abrasive cleaning agents, abrasive scourers
or sharp objects.

Case front

Please use only commercially available agent according to
the manufacturer's instructions for cleaning and mainte-
nance of the front surfaces.
Stainless steel surfaces can be cleaned and wiped dry
with mild detergents (eg soap) and a soft cloth. Aggressive
cleaning agents (eg vinegar-based cleaners), abrasives,
abrasive grit and sharp objects will damage the surface of the
device!
SteamClean-Function
This function facilitates the oven cleaning essentially,
because the dirt can be solved more easily by water vapor
and heat. Remove the accessories such as roasting pan,
baking sheet and rust.
• Pour down about 0.4 liters of water with a little detergent
into the trough of the soil.
• Close the oven. Select bottom heat heating at 50 °C.
• Switch off the unit after about 30 minutes and disconnect
the power. Remove soaked food debris with a cloth.
• Note the previous cleaning instructions for baked-on soils.
Oven
• The oven is easier to clean when it is still slightly warm.
Simple remove grease splashes with rinse water.
• Use conventional oven cleaner for stubborn or severe
soiling. Rinse thoroughly with cold water to remove all
cleaning agents are removed completely.
• When using oven sprays, observe the manufacturer's
instructions. Painted, anodized, galvanized surfaces, alu-
minum parts and radiators may not come in contact due to
possible damage and discoloration with these sprays.
• Clean the accessories such as baking tray, drip pan, rust,
etc. with hot water and a little detergent.
Hinge support

Remove the oven door

Fold down the oven door in the horizontal position.
Lift the bracket on the two door hinges to the front.
Slowly close the oven door until it stops. Then lift the door
until the hinges disengage.
The insertion is carried out in reverse order. At last, swing the
lever back to the hinge support.
Clip
29