Werbung
Dismantling
1. Dismount your tent in reverse order of the set up.
2. Loose all ground fixing and guy ropes but those 4 corners.
3. Let off the Air-In poles. On basic valves unsrew the valve completely. Comfort
valves stay open by pressing the valve and a quarter turn on "open".
4. Remove ground fixing at the 4 corners now.
Important advice for correct storage of all Air-In models!
- Storage temperature should be above 5° Celsius to avoid damage of the air
tubes.
- Fabric shall not become humid while stored. Humidity causes mold which
cannot be cleaned or washed away.
- Before final packing air tubes should be completely flat. The valves should not
be closed. Basic valves should be screwed only some turns to avoid loss of
small parts.
- Do not lay any heavy items onto the tent cover.
Find the clip of Luna Air here to show the set up of an Air-In tent:
https://www.dwt-zelte.de/en/advisor/assembly-instructions/assembly-instructions-
luna-air
Tips:
Take your time for the groundfixing and use all fixing options and guy ropes to
complete the set up properly. This way you avoid damages by wind and weather
conditions.
Check regularly the groundfixing and guy ropes. While temperature and humidity
changes fabric might extend or shrink. That might have an effect on the ground-
fixing. It could become loose and may cause damage!
Check pressure of air tubes! Also air volume in tubes is effected by changing
weather conditions. Low temperatures let pressure decrease, tent will be instable.
High temperatures cause higher pressure. Tubes could burst! Make sure that air
pressure is adjusted to weather conditions at anytime.
www.dwt-zelte.com
Werbung
