Pettec Remote Vibra Bedienungsanleitung Seite 28

How to pair remote control and remote trainer
If your remote trainer does not beep when the TONE button of the remote control is
pushed, or if you feel the remote trainer is not responding to the remote control, follow
these steps to pair:
1. With the remote trainer off your pet, turn the remote trainer off. Restart, press and
hold the On/Off button until the green LED light flashes every second on the remote
trainer. This continues for 16 seconds, within which pairing should be completed.
2. Press and hold the TONE and VIBRA button of the remote control at the same time
until the green LED light on the remote trainer flashes rapidly for 5 times, indicating
pairing is completed.
Two dog systems
Note: if you wish to add another remote trainer to the training system, extra remote
trainer is available where you bought your unit.
Pairing second remote trainer
1. Set the toggle switch to 2.
2. Turn on the remote trainer or dog 2, press any mode buttons to verify function.
3. If dog 2 remote trainer does not respond. Pairing may be needed. Repeat steps in
How to pair remote control and remote trainer.
28