Pettec Remote Vibra Bedienungsanleitung Seite 27

Charging receiver and remote
Lift the rubber covers protecting the remote controller/remote trainer charging jack.
Connect the charger connectors to the remote control and the remote trainer charging
jack, and as shown below. Connect the USB port to the charging adapter. Plug the char-
ger into a standard wall outlet. Charge the unit for 4 hours for the first charge. Rechar-
ges take only 2-3 hours. When charging is completed, remove the charger connector.
Note: The battery indicator on the remote control will scroll and the indicator light in
steady red while charging; and the battery indicator will become steady, and the LED
indicator light flashes when fully charged. The indicator light on the remote trainer will
be in steady red while charging and green light turned on when fully charged.
27