Werbung
Verfügbare Sprachen
Verfügbare Sprachen
23050L
•
Wear heat-resistant gloves when working.
•
Before setting the pin, make sure that tip of the switch grip is cold.
•
Do not touch heating repair pin with bare hands when it is set in the switch
grip.
•
Do not use near combustible materials.
•
Since it becomes high temperature, let people around you know it is
dangerous.
•
Do not use with wet hands.
•
Do not soak this product in water.
•
Do not use in wet locations.
•
When you suspend working, and leave the place, turn off the switch then
make sure that the tip of the switch grip has fully got cold.
•
Repairing objects get high temperature. Please be aware of burning by
melted plastic.
Please observe the following notes to avoid accident or breakdown.
•
This product was designated for plastic repair. Do not use it for purposes
other than the original usage.
•
The device may be used only with suitable brackets.
•
Please carry out use within 3 minutes, with a switch grip switched on.
•
The unit must be repaired only by authorized service personnel.
•
When you plug in and / or disconnect the plug, please hold the plug itself. (Do
not pull the cable.)
2. COMPONENT NAMES AND STANDARD PARTS PACKAGED
MAIN BODY ------------------------------------------------------------------- 1 UNIT
HEATING REPAIR PIN (V-SHAPED 0.6mm) ------------------------- 100 PCS / BAG
HEATING REPAIR PIN (U-SHAPED 0.6mm) ------------------------- 100 PCS / BAG
HEATING REPAIR PIN (U-SHAPED 0.8mm) ------------------------- 100 PCS / BAG
INSTRUCTION MANUAL ----------------------------------------------------- 1 COPY
V-Shaped 0.6mm
U-Shaped 0.6mm
U-Shaped 0.8mm
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Straße 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
Werbung
