D) Installation Of The Outdoor Sensors; E) Installation Or Setup Of The Basis Station - Renkforce 1380336 Bedienungsanleitung

d) Installation of the outdoor sensors

The outdoor sensors can be attached to the wall on a nail, screw or hook using the
opening (25) on the rear. The enclosed suction cups also permit attachment to a glass
pane.
The outdoor sensors are suitable for operation in the protected outdoor area. They
should be placed so that they are not subject to direct solar irradiation, because tem-
perature measurement will otherwise be incorrect. Precipitation on the outdoor sen-
sors also leads to incorrect temperature measurement because the casing cools off.
The same applies to measurement of humidity.
We therefore recommend careful selection of the site of set-up for the outdoor sensors
to be able to measure the correct temperature (and humidity).
Never immerse or submerge the outdoor sensor in water; it would be de-
stroyed!

e) Installation or setup of the basis station

The basis station can also be put on the wall using an opening in the rear (18) and an
nail, screw or hook.
A folding standing base (20) can be used to set up the basis station on a level, stable
surface. Protect valuable furniture surfaces from scratches with suitable pads.
37