Omnitronic WR-1BT Bedienungsanleitung Seite 22

Notes:
Some devices, such as iPhones, will connect immediately after pairing so that
the blue connection indicator will light up. Other devices, such as notebooks,
may ask you if you wish to connect and the LED will go off after pairing until a
connection is established.
Although the WR-1BT can only play music from one device at a time, it is
capable of being paired to up to 8 devices. Thus, you do not have to enter the
PIN code again when reconnecting a device.
You can play the music now. Just play music on your mobile device as you
normally would and the sound will come out of your stereo system. The
effective range of the WR-1BT is 10 meters.
Reconnecting your Device
If you move out of range or turn off the Bluetooth feature on your mobile
device, the WR-1BT will disconnect from your device. To reconnect, simply
open the Bluetooth manager and tap on "Music Receiver". You do not need to
enter the PIN again, the connection will be done automatically.
Adding a New Device
If you want to switch from one device to another, please follow these steps:
1 End the existing Bluetooth connection with the connected device.
2 The WR-1BT can now be connected with another mobile device.
3 Follow the section "Bluetooth Connection" to connect a new mobile
device.
Out of Range or Lost Signal
When the paired mobile device is too far away from the receiver (10 m) or
there is something blocking the Bluetooth signal, the blue LED goes off, i.e.
the connection between the mobile device and the WR-1BT is lost. To avoid
losing connection:
1 Move the music mobile device back into range (within 10 m), and make
sure there's a clear line of sight and there are no obstructions between
the WR-1BT and the device.
2 Within 15 seconds, the connection will automatically be reestablished
and the blue LED will light up.
3 If the connection is lost for more than 15 seconds, you need to reconnect
the device and the WR-1BT again. Please follow the "Reconnecting Your
Device" section.
www.omnitronic.de
22