Kasco marine 2400EA Bedienungsanleitung Seite 28

STEP FOUR
Place one of the three Angle Brackets (Part B4)per-
pendicular to the Base Strap at the front end of the
Base Strap. One of the two center holes of the Angle
Bracket should be positioned over the hole in the Base
Strap and the threaded hole in the Float. Secure the
Angle Bracket to the Float using three 1/4" x 1/2"
Stainless Steel Bolts and three Stainless Steel Lock
Washers. (See photos for specifi c instructions based
on the size circulator purchased.) Tighten all hardware
at this time with the 7/16" (11mm)socket and wrench.
Models 2400
& 3400 - Angle
posterior to bolts.
STEP FIVE
With a felt-tip marker, draw three to four marks
around the circumference of the motor housing at the
appropriate measurement from the back (or bottom) of
the motor housing given:
2400: 3/4" (1.9cm)
3400: 3-3/8" (8.57cm)
4400: 5-1/2" (14 cm)
8400, 2.3: 7-1/2" (19 cm)
STEP SIX
Place the two U-Brackets (Part B6) directly across
O
from each other (180 ) over the top ring of the motor
cage. The cord clamp on the cage should be 90
each of the U-Brackets
12
Model 8400, 2.3
& 4400 Angle
anterior to bolts.
O
from
1/4" x 1"
Bolt and
Locking
Nut
1/4" x 1-1/4"Bolt Power Cord
and Nut
.
STEP SEVEN
Insert the Spacer Bracket (Part B7)under the U-Brack-
et and inside the cage. Secure this assembly using one
1/4" x 1" Bolt (Part B9) and a 1/4" Lock Nut (Part
B11), and one 1/4" x 1-1/4" Bolt (Part B10) and a 1/4"
Hex Nut (Part B12). The longer bolt should be on the
side of the U-Bracket that is closer to the cord clamp.
Tighten the hardware using the 7/16" (11mm) wrench
and socket & wrench until the U-Bracket clamps
fi rmly around the cage (U-Bracket should pull together
slightly). Repeat with the second U-Bracket.
STEP EIGHT
Attach an Angle Bracket to each of the longer (1-1/4")
bolts on the U-Brackets (See photo for orientation)
with a 1/4" Lock Nut.
2400 & 3400
1/4" x 1"
Bolt and
Locking
Nut
1/4" x 1-1/4"Bolt
and Nut
4400 & 8400, 2.3