Circulator Parts (Ec Models); Circulator (Ec Model) Assembly - Kasco marine 2400EA Bedienungsanleitung

as the water level rises. This can also help hide ropes
by sinking them further below the surface.
Normal Water level
Anchor Rope
Secondary Weight
Low Water Level
High Water Level
STEP THREE
At this time the Aerator is ready for operation. The
unit can now be connected to the electrical circuit
(fi xed wiring) with a plug or direct wire connection.
The circuit must be provided with a disconnect switch,
short circuit, and ground fault protection (RCD).
Refer to unit specs for voltage and amperage ratings.
Also, the motor name plate lists the unit's electrical
ratings. Electrical installation must follow local and
national electrical codes and should be installed by a
professional.

Circulator Parts (EC Models)

Circulator (Unit with cord or stub cord) (1)
Float in separate box (1)
1. Float (1)
2. Base Strap (1)
3. Adjustment Bracket (1)
4. Angle Bracket (3)
5. Draw Band (1)
6. U-Bracket (2)
7. Spacer Bracket (2)
8. 1/4" x 1/2" Stainless Steel Bolt (8)
9. 1/4" x 1" Stainless Steel Bolt (3)
10. 1/4" x 1-1/4" Stainless Steel Bolt (2)
11. 1/4" Stainless Steel Lock Nut (8)
12. 1/4" Stainless Steel Hex Nut (2)
13. 1/4" Stainless Steel Lock Washer (5)
14. 50' Black Nylon Ropes (2)
15. Nylon Tie (1)
Kasco Power
Control Box
Power Cord
Circulator Tools & Supplies Needed
A. Anchors or stakes for installing unit (2)
B. 208-240V Electrical Supply near pond on a post
C. 30cm pieces of 2.54cm galvanized pipe for weight-
ing ropes (optional) (3)
D. 9/16" (14mm) & 7/16" (11mm) Nut Driver
E. 9/16" (14cm) & 7/16" (11mm) Socket
F. Adjustable crescent wrench
G. 7/16" Wrench (1)
H. 7/16" Socket & Wrench (1)
I. Felt-tip marker (1)

Circulator (EC Model) Assembly

STEP ONE
Remove all contents from package and place on a
clean, fl at surface. Inspect the shipment for any dam-
ages. Make sure you have all the parts needed.
STEP TWO
Position the Float (Part B1)upside down (lengthwise
channels facing up) and place the Base Strap (Part B2)
so the three holes in the Base Strap align with the three
threaded holes that comprise the lengthwise midline of
the Float.
STEP THREE
Position the Adjustment Bracket (Part B3) over the
two holes at the back end of the Float and Base Strap.
Loosely secure the Adjustment Bracket to the Float us-
ing two 1/4" x 1/2" (Part B8) Stainless Steel Bolts and
two Stainless Steel Lock Washers (Part B13). (See
photo above for orientation.)
11