Mounting/Placing Of Sensors; Wind Sensor; Temperature / Humidity Sensor - Oregon Scientific WMR89A Bedienungsanleitung

The battery icon indicator
following areas:
AREA MEANING
Weather Forecast
It displays
Area
adaptor is disconnected.
Low battery in the main unit or
Temperature or
outdoor sensor for displayed
Humidity Area
channel.
Wind Speed / Wind
Direction / Wind Chil Low battery in wind sensor.
Area
UVI / Barometer / Low battery in UV/Rain
Rainfall Area sensor.

MOUNTING/PLACING OF SENSORS

WIND SENSOR

Make sure the wind sensor is connected to the base
station before installation.
To check the connection:
Press SELECT until the selected area icon
top right display area.
• Wind speed: Gently rotate the wind vane and confirm
a numerical reading on the base station, e.g.
• Wind direction indicator. Move the direction of the
wind indication and verify the icon moves in the same
direction .
The sensor should be positioned in an open area
away from trees or other obstructions.
To install the wind sensor:
a
Secure the sensor connector in the desired location:
a. Align the back of the sensor connector to an existing
pole. Secure in place by inserting the ends of the
U-bolt into the holes on the sensor connector and
securing it with washers and bolts.
OR
appears in the
when the AC
is in the
.
b
b. Insert 4 type A screws into the holes of the sensor
connector. Screw firmly into place, i.e., fence.
Slide wind vane onto the smaller end of the sensor
connector.
IMPORTANT Make sure the wind sensor points to north
in order to record accurate readings.

TEMPERATURE / HUMIDITY SENSOR

Make sure the temperature/humidity sensor is
connected to the base station before installation.
To check the connection:
1. Press SELECT until the selected area icon
the bottom left display area.
2. Press UP / DOWN to select channel 1
a numerical reading.
To install the temperature/humidity sensor:
1.5 m (5 ft)
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 meters (5 feet) and which can shield it from
direct sunlight or wet conditions for an accurate reading.
5
is in
and verify