Rain Gauge; Backlight; Clock Reception - Oregon Scientific WMR89A Bedienungsanleitung

Secure the sensor in the desired location using the wall
mount bracket or table stand.

RAIN GAUGE

The base station and rain gauge should be positioned
within an effective range: about 100 meters (328 feet)
in an open area.
The rain gauge should be mounted horizontally about
1 meter (3 feet) from the ground in an open area away
from trees or other obstructions to allow rain to fall
naturally for an accurate reading.
Make sure the rain gauge is connected to the base station
before installation.
To check the connection:
1. Press SELECT until the selected area icon
the middle right display area.
2. Press MODE repeatedly until
3. Tilt the tipping funnel on the rain gauge several times,
wait for a few seconds and then verify a numerical
reading on the base station.
If no reading displays, press the SEARCH button on
the back of the base station to initiate a wireless sensor
search.
To ensure a level plane:
Put a few drops of water on the cross at the base of the
funnel to check the horizontal level.
Water will pool to the center of the cross when the rain
gauge is level.
If water remains on 1-4, the gauge is not horizontal.
If necessary, adjust the level using the screw.
is in
displays.
1
3 2
4
NOTE For best results, ensure the base is horizontal to
allow maximum drainage of any collected rain.
TIP Press RESET button on back of the base station to
erase all testing data.

BACKLIGHT

Press LIGHT to activate the backlight for 5 seconds.

CLOCK RECEPTION

This product is designed to synchronize its calendar
clock automatically once it is brought within range of a
radio signal:
WMR89:
• EU: DCF-77 signal: within 1500 km (932 miles) of
Frankfurt, Germany.
• UK: MSF-60 signal: within 1500 km (932 miles) of
Anthorn, England.
Slide the EU/UK switch to the appropriate setting based
on your location. Press RESET whenever you change
the selected setting.
WMR89A:
• WWVB-60 signal: within 3200 km (2000 miles) of Fort
Collins Colorado.
The reception icon will blink when it is searching for
a signal. If the radio signal is weak it can take up to
24 hours to get a valid signal reception.
status of the clock reception signal.
ICON MEANING
Time is synchronized.
Receiving signal is strong.
Time is not synchronized.
Receiving signal is weak.
To enable (and force a signal search when previous
search was unsuccessful)/disable the clock radio
reception:
1. Press SELECT repeatedly to navigate
clock/calendar/moon phase area.
2. Press and hold SEARCH.
enabled.
NOTE For best reception, place the base station on a
flat, non-metallic surface near a window in an upper floor
of your home. Place the antenna away from electrical
appliances do not move the antenna when searching
for a signal.
6
indicates the
icon to the
displays when it is