Omnitronic wams-08BT Bedienungsanleitung Seite 14

5
SETUP
Inserting Batteries
1
For operation, the transmitter requires two 1.5 V AA batteries. Fold up
the cover of the battery compartment and insert two batteries as
indicated in the compartment.
2
With new batteries, the transmitter can be operated for approx. 10
hours. The battery indicator lights up after switching on. If it fails to
light up, new batteries must be inserted.
3
If the transmitter is not used for a longer period (approx. 1-2 weeks),
please remove the batteries to prevent damage in case of battery
leakage. Please refer to further explanations in chapter Operating
Determinations.
Fastening the Pocket Transmitter and Connecting the Microphone
1
Attach the transmitter with the belt clip to your clothing or strap on
your instrument.
2
Connect the included microphone to the microphone input. Always
make sure the jack plug is properly screwed into the connection
terminal; otherwise loose contacts and noise may result.
Operation
1
Set the sliding switch to "ON" to switch on the transmitter. The power
indicator lights up.
2
After switching on the transmitter, a radio connection to the receiver is
set up. If the reception of the radio signal is of sufficient power, the
reception RF indicator on the PA system lights up. Adjust the desired
volume of the audio signal received with the control WIRELESS
MICROPHONE.
Note: Always use either the pocket transmitter or the handheld
wireless microphone of the PA system.
3
To mute the transmitter during operation, set the sliding switch to its
center position. Then no sound will be transmitted.
4
To switch off the transmitter, set the sliding switch to "OFF".
www.omnitronic.de
14