GIS TS-MX300-HF Bedienungsanleitung Seite 12

TS-MX300-HF
(13,56 MHz System)
Handling
Handling of the menus:
In the menus, selection is done using the
next higher menu level is loaded. Use
the lower level menu or the attached function. The active menu item is shown in bold.
Handling of input masks:
In the input masks with numeric input the number keys are used for number input. To
switch to the next field the ON key is used. The arrow keys are selected by pressing
SHIFT key simultaneously. Using the arrow keys
next field.
At the bottom of the input mask you will use the field
storing changes. If the field
only be leaved if the input value is in valid range (Number is shown in green color). If
the input value is invalid, it is shown in red color.
Exit:
All menus, input masks or even MX300 Basic applications can be left using the
SHIFT+Clear key. Take care to pres both keys at the same time!
Menu structure extended / reduced
By default the extended menu is shown. It can be switched to reduced menus also. The
switch between reduced and extended menus can be protected by a User PIN. In the
following menu structure, all menu items which are available only in extended mode are
shown in italics and in
The setup of the User PIN is done in Define PIN. This is protected by the System PIN.
User PIN and System PIN are both defined with up to 6 digits. If the User PIN is kept
empty, the menu switching is done directly. If the System PIN is kept empty, Define PIN
can be called without protection.
GiS Gesellschaft für Informatik und Steuerungstechnik mbH * Tel: +49 (0)7026-606-0 * Email: rfid@gis-net.de
Ç È
Æ
or
is used, changes are stored. A numeric input field can
grey.
Å
keys. Using the menu is left and the
C or ON to select a menu entry and open
Ç È
you can switch to the previous /
to leave the mask without