Replacement Of Batteries - GIS TS-MX300-HF Bedienungsanleitung

TS-MX300-HF
(13,56 MHz System)
Starting up:
The device is delivered ready to use. Turn on the device using the ON key.
After turning on the main menu appears or a user specific application is started.
If an application is started, this can be closed by pressing both

Replacement of Batteries

The device runs with AAA NiMh or Alcaline batteries. To change batteries remove the
battery cover at the back side. You have to remove the screws using an appropriate
screwdriver and then lift the cover. Extracting the batteries is allowed only if device is
turned off. If batteries are replaced within some minutes, date and time is conserved.
Recharging of NiMh rechargeable batteries has to be done using a separate NiMh
recharger. This item is not included in delivery.
Increase battery lifetime
The TS-MX300 is equipped with intelligent Power-saving technology.
However, it requires some diligence of the user to minimize power consumption.
- So the Bluetooth interface should be activated only while it is used. An activated
Bluetooth interface shortens the battery lifetime substantially! This is especially true
while the connection is not established.
- The more brighter the display background is enlightened the more power is consumed
which results in lower battery lifetime.
- Select the turn off delay as short as possible, so the device so not turned on
unnecessary long time.
- Please take care of the hints to power consumption in MX300 Basic manual when
programming with MX300 Basic.
GiS Gesellschaft für Informatik und Steuerungstechnik mbH * Tel: +49 (0)7026-606-0 * Email: rfid@gis-net.de
SHIFT and Clear.