Operation; Maintenance / Cleaning - indexa Pentatron TF04M Bedienungsanleitung

User Manual
1. Introduction
Read through this user manual completely and carefully.
handset is for use together with the TF04 Set, refer also to the manual of the
set. The manual of the set is the master manual and it contains the safety
instructions and information relating to the location, installation,
connection and use of the handset.
Always observe all the safety instructions. If you have any questions or are
unsure about using the equipment, ask a specialist or obtain information on
line at www.indexa.de. Keep this manual in a safe place and pass it on to
third parties if necessary.
2. Proper use
The additional handset TF04M consists of a handset TF04M with a charger
TF04L and mains adapter. The additional handset is suitable for use with
the door intercom TF04 Set. It must be registered to the base TF04B.
The door intercom TF04 Set can be expanded with up to three further
handsets TF04M. Internal communication between handsets is possible.
The system uses DECT/GAP standard. Compatibility with components from
other manufacturers cannot be guaranteed. The door opening function is not
available in combination with such components
The handset, charger and mains adapter must be kept dry. The charger is
powered through the 7.5 V DC mains adapter which is connected to
230 VAC, 50 Hz. The handset is powered by two Ni-MH rechargeable
batteries which are automatically recharged when the handset is placed in
the charger.
Any other use or modification of the equipment is not authorised and
presents significant risks of accident. No liability will be accepted for
consequential damages or for damages caused by improper use or incorrect

operation.

This equipment is not suitable for use by persons (including children) with
limited physical, sensory, or mental abilities or with lacking experience or
lacking knowledge unless they are supervised by a person responsible for
their safety or obtain instructions on how to use the equipment. Children
must be supervised to make sure they do not play with the equipment.
3. Package contents
!
Handset TF04M
!
2x AAA Ni-MH Batteries
!
Charger TF04L
!
Mains adapter 7.5V for charger
!
User Manual
4. Technical data
Handset TF04M
Power supply: 2x Ni-MH batteries AAA, 1.2 V; 600 mAh
Charging voltage: from charger
Initial charging duration: 15 hours
Standby time: up to 180 hours
Talk time: up to 8 hours
RF range to base: up to 30 m indoors, up to 200m in free space
RF modulation: GFSK
GB
Operating temperature:
Dimensions:
Weight:
As the additional
Changer TF04L
Operating voltage:
Current consumption:
Operating temperature:
Dimensions:
Mains adapter
Power supply:
Power output:
Application:
5. Operation
Refer to user manual TF04 Set
Operation
!
Connect the mains adapter of the base to the power supply. The handset
will beep twice.
The batteries in the handset are charged automatically after the
handset has been placed in the connected base.
fully charged for about 15 hours before initial operation.
battery charge indicator on the display display [41] (three black bars
= batteries are fully charged, one black bar = very low battery
power). If the batteries do not reach their full capacity after charging,
they should be replaced. When you place the handset in the base, it
automatically turns on.
Registration of further handsets
!
Press and hold the pager button on the bottom of the base for at least 5
seconds.
!
Press the "Menu" key
!
Press the
!
Press the "Select" key
!
Use
!
Press the "Select" key
!
As soon as the base is found, and the handset is successfully registered,
you will be prompted to enter the PIN code (the default one is 0000).
!
Press the "Select" key
registration tone will sound and the base assigns a number to the
handset. If the PIN code entered is invalid, a warning tone will sound,
and the handset will return to the previous registration state. If the base is
not found, the handset will behave according to the Out of Range
condition.
6. Mai
#
The units are maintenance-free. Do not open them.
#
Regularly check the technical safety and function
#
Before you clean the device, pull the mains adapter out of the mains
socket.
#
Use a soft, dry or slightly moist cloth or a dry brush for cleaning the
surfaces.
0 °C to +40 °C
approx. 48 x 159 x 29 mm
approx. 132 g
7.5 V DC (mains adapter)
max. 300A,
0 °C to +40 °C
90 x 90 x 60 mm
230 V, 50 Hz, 150 mA
7.5 V,300 mA, 2.25 VA
indoor use only
.
or key repeatedly to choose "Registration".
.
or key to scroll through the base names list.
to choose a base.
. On validation of the PIN code, the
ntenance + cleaning
The batteries should be
Watch the
GB - 6