m-e CT-Pin Betriebsanleitung Seite 16

EN
f.) Before the LED on the receiver stops
flashing, press the "Learning" button (3)
on the wireless motion detector that you
want the Cuveo receiver to learn. The red
LED on the receiver stays lit. The learning
process has been completed successfully.
g.) Repeat these steps for additional receivers.
h.) Following successful completion of the
learning process, re-assemble the wireless
motion detector housing. Place the wireless
motion detector electronics in the fixed
mounting plate, making sure that the arrow
is pointing downwards.
i.) Then place the front plate with diffuser lens
back on the electronics part. Again make
sure that the arrow is pointing downwards.
The front plate snaps in and the wireless
motion detector is ready for use.
16
Deleting the wireless motion
detector on a Cuveo receiver
Please refer to the instructions in the
user guide for the Cuveo receiver.
FUNCTION TEST /
OPERATION
Connect a load to the programmed Cuveo
receiver. For reliable, maximum performance
of the load, refer to the "Technical data"
section for the respective Cuveo receiver.
Walk through the sensing range of the
wireless motion detector. If the "H...L"
slide switch is set to "L", this test is
only possible at dusk or at night. The
programmed Cuveo receiver should then be
activated for the set time. Each additional
movement that is detected extends the
time that the programmed Cuveo receiver
is activated.