m-e CT-Pin Betriebsanleitung Seite 14

EN
The product must not be modified or altered
in any way!
This product satisfies national and European
legal requirements.
MOUNTING THE WIRELESS
MOTION DETECTOR
The wireless motion detector is suitable
for indoor use. The wireless motion
detector should be positioned at least
1 metre away from lights, heaters, and
other sources of heat so as not to cause
faulty operation.
Make sure that cables or lines are not
damaged when drilling holes in the wall
or screwing in the mount.
In order to ensure optimum detection,
the motion detector must be positioned
so that the object to be detected does not
14
approach the motion detector, but passes
it from left to right or vice versa. This
should be taken into consideration when
mounting the wireless motion detector.
a.) Open the front plate with diffuser lens by
carefully lifting off the front plate using
a screwdriver.
b.) The rear mounting plate has two mounting
holes. Take the mounting plate and mark
the mounting holes where you intend to
mount the unit.
c.) The wall mount is fixed to the wall with
two screws. Drill the marked holes and fix
the wireless motion detector in place with
appropriate screws. (Use screws and, if
necessary, wall plugs that are suitable for
the mounting surface.)
d.) Place the wireless motion detector
electronics in the fixed mounting plate.