m-e CR-RO500 Betriebsanleitung Seite 19

c.) Before the LED (1) stops flashing, press
the "ON" button for the respective switch
channel on the wireless transmitter that
you want the wireless flush-type switch
to learn. The red LED (1) lights up. The
learning process has been completed
successfully.
Teaching a wireless
flush-type switch to
recognise multiple
wireless transmitters
The "Roller shutter" wireless flush-type
switch can learn up to 8 wireless
transmitters.
a.) Connect the "Roller shutter" wireless
flush-type switch to a standard 230 V AC
mains voltage in the correct manner, as
described in the section above.
b.) Press the button (2) until the LED (1)
flashes red.
c.) Before the LED (1) stops flashing, press
the "ON" button for the respective switch
channel on the wireless transmitter that you
want the wireless flush-type switch to learn.
The red LED (1) lights up. The learning
process has been completed successfully.
d.) Repeat these steps for additional
wireless transmitters.
Deleting a wireless
transmitter that the wireless
flush-type switch has already
learnt
Channels that have been learnt can also
be deleted again.
a.) Connect the "Roller shutter" wireless
flush-type switch to a standard 230 V AC
mains voltage in the correct manner, as
described in the section above.
EN
19