m-e CR-RO500 Betriebsanleitung Seite 17

MOUNTING AND
CONNECTING THE ROLLER
SHUTTER WIRELESS
FLUSH-TYPE
The "Roller shutter" wireless flush-type
switch is only designed and suitable for
operation in a dry location indoors. It
may only be mounted and operated in an
appropriate flush-type or surface box or
another appropriate type of housing.
If the "Roller shutter" wireless flush-type
switch is installed after the existing up/
down switch, the flush-type box must
provide sufficient space to allow this.
Alternatively, the "Roller shutter" wireless
flush-type switch can be inserted in
another flush-type box near the shutter
up/down switch
ATTENTION:
Installation may only be carried out
when the power is disconnected. To
do this, disconnect the mains supply
line by switching off or unscrewing the
corresponding fuse. In addition, switch
off the corresponding residual current
circuit breaker so that all the poles of the
mains supply line are disconnected from
the mains voltage. Prevent unauthorised
reconnection and verify that the relevant
mains supply line is isolated from
the supply. Only one motor may be
connected to the "Roller shutter" wireless
flush-type switch. The "Roller shutter"
wireless flush-type switch is not able to
detect the end position of the shutter/
roller shutter. Only connect a motor that
has its own switch-off function for when
the top and bottom end positions
are reached.
Please refer to the safety notes when
connecting the "Roller shutter" wireless
flush-type switch.
EN
17