Wall Mounting (If Using Option-C) - Blaupunkt LS 2400 Bedienungsanleitung

Wall Mounting (if using option-C)

Note:
• Installation must be carried out by qualified personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer's responsibility to verify that the wall will safely support the total load of the unit and wall
brackets.
• Additional tools (not included) are required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future reference.
• Use an electronic stud finder to check the wall type before drilling and mounting.
1. Remove the screws from the main unit.
2. Attach the wall brackets to the main unit with the screws removed from the main unit.
3. Drill 2 parallel holes (Ø 3-8 mm each according to wall type) in the wall. The distance between the
holes should be 767 mm.
4. Firmly fix 1 dowel into each hole in the wall if necessary.
5. Leave a 5 mm gap between the wall and the screw's head. Lift the unit with the attached wall
brackets over the heads of the screws and slot into place.
1
3
767 mm
2
4
7
5
5 mm
25-30 mm