Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
www.inline-info.com
9.5 The volume is too low
In TX mode: Adjust the volume on your Bluetooth headset / speaker, TV, or any other connected
device as they can control the volume.
In RX mode: Check the volume settings of the operating system of your PC and the software
player you are using. Also, check the volume settings of your speakers or music system.
9.6 The sound quality is bad and / or the audio output has small dropouts
1. Maximize the volume of your audio source (TV, music system, active speakers, etc.), and then
control the volume using the Bluetooth headphones, speakers, or smartphone.
2. Make sure that you are within the range of your Bluetooth-enabled device.
3. Bluetooth devices are susceptible to interference from other Bluetooth devices, cordless pho-
nes, routers, microwave ovens and other wireless devices operating on the 2.4 GHz band. Elimi-
nate as many potential sources of interference as possible while using your Bluetooth headphone
/ speakers.
9.7 Delay (latency) during audio playback
1. Bluetooth is a digital wireless signal and there is some latency expected due to coding / deco-
ding and compression / decompression steps must occur.
2. The aptX and aptX low latency audio codecs supported by transceiver are notable for having
lower and much lower latency (smaller delay), respectively, compared to regular Bluetooth audio.
3. Using the audio transceiver with a headphone that supports aptX or aptX low latency will mini-
mize audio lag.
10. LED INDICATIONS
LED indicator
LED off
Blue indicator light pulsing slowly
Green indicator light pulsing slowly
Blue and red light flashing
Green and red light flashing
Solid blue light
Solid green light
Connection status
Transceiver is off
Transceiver is on with OPT selected
Transceiver is on with AUX selected
Pairing in TX/RX mode - OPT
Pairing in TX/RX mode - AUX
Successfully paired - OPT
Successfully paired - AUX
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
