Other Functions; Reconnection; Adjust The Volume; Restore Factory Settings - Inline 99150l Bedienungsanleitung

Bluetooth audio transceiver, sender / empfänger, bt 4.1, aptx, klinke + toslink

Inhaltsverzeichnis

Verfügbare Sprachen

www.inline-info.com

Step 2: With the transceiver powered on and TX/RX toggle switch set to „RX", slide and hold the

multifunction switch all the way to the right in the direction of the Bluetooth symbol. The LED in-

dicator will flash red and blue / green to indicate that transceiver is ready to pair. Now release the

multifunction switch.

Step 3: Turn on Bluetooth on your device and go to Bluetooth preferences. If necessary, refer to

the operating instructions of your device.

Step 4: Scan listed Bluetooth devices and select „InLine BT Transceiver" to pair and connect. Once

paired, the LED indicator will turn to solid blue / green (depending on the audio input selection).

Step 5: Make sure the proper audio output source is selected on transceiver. Match the correspon-

ding audio output (optical or AUX) on the back of the transceiver using the multifunction switch.

Step 6: The music on your smartphone / tablets / PC will now play through your home stereo

system.

8. OTHER FUNCTIONS

Previously paired Bluetooth devices will reconnect to transceiver automatically, as long as the

transceiver and the paired Bluetooth devices are turned on.

The audio transceiver, by design, is a passive transmitter or receiver and has no volume control.

User volume level must be adjusted via the input and output sources connected to transceiver.

With audio transceiver powered on, slide and hold the multifunction switch all the way to the right

for approximately 6 seconds until the LED indicator shows solid static light. Release the multi-

function switch when the light flashes red and blue. The unit has entered pairing mode and any

previously paired devices will be cleared from its memory.

Confirm that the power adapter is connected to transceiver with the included USB cable and

plugged into a functioning AC outlet. The blue LED indicator on the front of the unit will light up -

pulsing slowly when the unit is turned „ON" by setting the TX/RX toggle switch on the rear of the

unit to „TX" or „RX".

Inhaltsverzeichnis

Inhaltsverzeichnis