Please note when installing the bowl!
•
When mounting, the regulations DIN 1988 / DIN EN 1717 must be observed
(Protection of drinking water).
•
The KU SB 12 valve is suitable bar for a water line pressure of 1 to 5 bar.
•
The SB 12 KU N valve (low pressure) is suitable for a bar water pressure to 0.3.
•
When installing where the water pressure exceeds 5 bar to avoid problems, it is
possible to build a pressure reducing valve in the supply line.
•
Only use low sealing tape for thread connection, do not use hemp.
•
When connecting the supply lines to the drinking bowl, pay attention to
cleanliness (No residue in the pipe, such as metal chips, sand, debris, etc.).
•
With well water, make sure that the water is clean and free from suspended
particles, otherwise the function of the valves is not guaranteed.
•
In a corresponding unclean water filter unit (sediment filter 5-20μ / h / iron filter /
activated carbon filter) should be used.
•
Ventilate the pipe well! Carefully screw the plastic connection (not excessively use
too much gasket material)
•
Non-heated water bowls and water lines must be protected from freezing at low
temperatures.
Installation instructions: