MA lighting MA 8Port Node Bedienungsanleitung Seite 41

Quick Start
These are the basic steps to start up the MA 8Port Node::
download
grandMA2 onPC software from MA-Homepage and install software on PC or Laptop. For
minimum requirements see : www.malighting.com
The 8Port Node is supported by grandMA2 consolen / grandMA2 onPC with software V2.9 and higher.
connect MA 8Port Node (100 - 240V∼ (+/- 10%) ,50 or 60 Hz).
Connect the MA 8Port Node using a network cable (RJ45 plug). Either via the switch / hub or by directly
plugging it into a PC or laptop computer or grandMA 2 console.
start grandMA2 –console or grandMA2 onPC and switch on MA 8Port Node (set main switch at the back to
„I"). It takes about 30 seconds until the MA 8Port Node ist ready.
The MA 8Port Node display will only show the most important settings. For configuring a node, you have to use
a grandMA console or the „onPC" software.
Open menu SETUP / CONSOLE XYX / SOFTWARE UPDATE at the console or onPC..
If necessary update firmware-version of MA 8Port Node – (necessary when area "Version" is red colored.
if necessary change IP – address of MA 8Port Node. When several MA 8Port Node are available, the
respective node can be identified with button IDENTIFY - display and LED of the selected node flashes) - (not
for version 2.8)
Name the MA 8Port Node (optional).
select mode.
select session ID (only at MANET) – use same ID as used in session of console or onPC.
select function (IN, OUT or NONE) of DMX-Ports and set univers number.
connect DMX-cable at the back side
Turn OFF
Set main switch an the back side to position „O".
Note:
Disconnecting the MA 8Port Node from your PC or notebook is always possible – however DMX –output is
interrupted immediately.
Show is always stored on your PC or notebook, not on your MA 8Port Node.
For longer non use disconnect all cables.
- ready.
MA 8Port Node
Data
Transport
Safety
instructions
Safety and
environmet
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
40