Maintenance And Care; Technical Data/Specifications; Warranty - MyTinySun folkslight 1 GoPro Light Bedienungsanleitung

mode repeat the procedure of
approximately 7 seconds. Otherwise the SOS-mode conti-
nues until the battery is fully discharged, because this is an
emergency scenario.

maInTenanCe and Care

There are no user serviceable parts inside the folkslight sys-
tem. However, certain aspects should be taken into conside-
ration to ensure a trouble-free running.
Light: Remove dirt with the help of some water. Only use a
mild cleaning agent if necessary. Please note that the light is
not suitable for cleaning with high-pressure cleaners! In the
case of water intake into the lamp housing, switch it off and
immediately remove the battery cells and do not use it until
you are sure that all moisture has been removed. In case of
doubt please contact our customer support. Proper use will
prevent water intake. Hence, disassembling the housing will
not be necessary. The disassembly of the light will invalidate
warranty. Please consult our customer support before opening
the light.
Battery: If you will not use the folkslight system for an exten-
ded period of time, it is important to recharge the battery up
to a capacity of approximately 55% - 75% prior to storage.
Further information and tips can be found at:
www.mytinysun.com „Support/FAQ/How to store MyTi-
nySun Lithium-Ion-batteries when not in use for an extended
period of time"
pressing the rear button for
w w w . M y T i n y S u n . c o m

TeCHnICal daTa/sPeCIFICaTIOns

• Double LED light, LED Typ: Cree XM-L, selected.
• Up to total nominal light output of 2000 lumens.
• 2 Lenses, 20 mm, beam angle 17° and elliptical
18° x 45°.
• Housing and mount: Plastics, several designs.
• Lightbody: Aluminium.
• Water resistant to splashes of water, jet-water and
occasional immersion according to industry standard IP67.
• Battery: Li-Ion, typ 18650 (Only MyTinySun permitted
batteries are allowed).
• USB port with charging function (0.5 - 2.0A at each USB
port) for internal batteries and software update function.
• 9 axes motion sensor for controlling via movement.
• Front side located light sensor for controlling via light.
• Temperature for operating and storage: -20° - +60°
• Dimensions (mm) ca.: L 100 x H 52 x D 44.
Weight ca.: 230 g

warranTY

We extend warranty services beyond statutory services of the
implied warranty. Warranty is offered besides statutory cus-
tomer rights against the seller which are not affected by this
service. If you are a first-time purchaser and you would like to
call on our warranty services, please send us the under www.
mytinysun.com/„warranty" provided explanation.