MyTinySun folkslight 1 GoPro Light Bedienungsanleitung Seite 13

OPPeraTInG
Security-lock: To prevent the light from unintended use, the
security-lock is activated in the delivery state of the light. Swit-
ching the light on is not possible. If you
the activated security-lock will be indicated by its
flashing red.
Unlock (security-lock off): Press and hold
first, in addition press the rear button
green.
Lock (security-lock on): You have to switch the light complete-
ly off to activate the lock (see chapter
Press and hold the front button
rear button Status-LED turns
until its
NOTE: Although the security-lock is activated the light can be
charged.
Selection of operating mode "Simple" or "Expert":
Note: The light has been delivered factory-preset in the sim-
ple mode. It can be switched on immediately in this mode.
Each time you want to change
mode the light needs to be
LED and main light are off), then
button until the light switched off again
light off). This takes approximately 20 seconds.
Note: The Status-LED and the main light will show the SOS
mode once during that switching phase.
Selection of programs of switching stages in the Expert Mode:
The light needs to be switched off completely
push rear button,
the
Status-LED
the front button
until its Status-LED turns
„Switch off the light").
first and in addition press
green.
between simple and expert
switched off completely (Status-
push and hold the rear
(Status-LED and main
(Status-LED and
w w w . M y T i n y S u n . c o m
main light off). Now,
proximately 5 seconds. This will cause the
for 5 seconds or flash 6 times
to the current activated program of switching stages.
these five seconds, it is possible by
several times, to
stored programs of switching stages (see supplemental sheet).
If you do not push the button within 5 seconds, the indica-
ted program will be selected and stored. The light turns on
automatically at the lowest light power switching stage. The
light will remain in the selected program until you start a new
selection.
the
Switch on the light in simple mode (delivery state):
the rear Button about 1 second
dimmed switching stage (40%). The rear
briefly red
and after two seconds the battery charge Level
will display.
Switch on the light in expert mode:
about 1 second
switching stage of the selected program. The rear
will show the color
2 seconds (see supplemental sheet).
check, battery condition
or the main light
supplemental sheet).
Note: By indicating the battery condition via the main light,
the Status-LED glows bright red and serves as a position light.
push and hold the rear button
Status-LED
showing the color according
pushing
switch from one program to the next
switches on the light in the
Status-LED
Pushing
switches on the light in the lowest light power
of the selected program
after a brief
will be indicated via the
according to the selected program (see
for ap-
to flash
Within
the rear button
of the
Pushing
will turn
the rear Button
Status-LED
for approximately
battery
Status-LED