Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation:
This product may only be installed by a qualified specialist electrician.
Before the installation is done, the connection lines to the building must be
switched free from voltage and protected against being switch on again.
Take the appropriate automatic circuit breakers out of the junction box in the
building.
Protection of the outside light with a default current circuit breaker is
recommended when it is being used outdoors.
Make sure that no water can collect at the place where the light is fastened.
The minimum distance to the objects to be illuminated must not be less than 0.5 m.
Make sure that the base is suitable to support the weight of the light permanently and reliably.
Hold the light holder in the required installation position and mark the holes to be drilled. Use suitable
screws with a maximum diameter of 6 mm for fastening the light. Make sure that no lines are damaged.
Feed the supply lines for the power supply through the opening in the installation casing.
Now connect the connection lines at building installation to the screw terminals of the light . Connect up
the yellow-green ground wire first of all and then the other two lines. The brown (or black) cable is
usually the phase conductor, connect this to the terminal marked with an "L". The blue conductor must
be connected to the terminal marked with an "N".
Do not bend the cable, make sure that the cable and the plug are free from strain and rotational forces.
Protect all cables and insulations from damage which may occur.
Check again for proper connection and close the housing cover again. Make sure that the gasket has
been properly seated.
Push the dowels into the drilled holes and fasten the installation casing by using suitable screws. Make
sure you have a stable and reliable fastening. Fasten the light housing to the fastening clip. Make sure
that you have a safe and reliable fastening.
Unscrew the light housing by turning in the clockwise direction and install the illuminant. Screw the light
housing back onto the base by turning clockwise. Make sure the fitted seal has a proper seating.
Switch on the circuit breakers of the junction box in the building again.
The name plate must not be removed.
Installation instructions Art. No. 39580
Page 2 of 2
®
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Status 09.2011
Werbung
