Nfc Pairing - Imperial BART 1 Bedienungsanleitung

E
6. OPERATION
Please note:
Plugging in the analogue 3,5 mm stero jack cable to output
10 disables the optical output 9.
> Push the MOdE button as often, until the blue RX LEd
starts blinking.
Now, you can start pairing the BART 1 with your Bluetooth audio
device, in order to start reception.
> Start searching for Bluetooth devices on the product,
from which you want to transmit audiosignals to BART 1.
Please read the manual of this product also.
Once the connection is established, the blue RX LEd shines
permanently.
> Now you can start playing songs on your connected device.

6.1.2 NfC PAIRING

If your mobile device supports NfC communication, you can establish
the bluetooth connection automaticaly, without any searching
process.
> Enable NfC on your mobile device and hold NfC label of this
device close to the NfC label on BART 1.
The pairing and connection starts automaticaly.
> Holding the mobile once again to the NfC label, will
disconnect the devices.
user Manual
36