Cooling/Warming Process; Tips For Achieving The Best Cooling Power - AEG BK 6 Bedienungsanleitung

Cooling/warming process

1. For reasons of hygiene, clean the inside of the board bar with a damp cloth before
every use.
2. Fill the board bar with the items you wish to cool/warm.
3. Set the switch (8) to the "oFF" position.
4. Plug the 12 V plug (13) into the 12 V connection socket (9) on the device.
5. Connecting the power supply:
▪
option 1:
Plug the car power plug (14) into a 12 V car power socket. The red LEd (12) will
light up.
▪
option 2:
Plug the car power plug (14) into the 12 V socket (15), then plug the 230 V mains
plug (11) into a mains socket. The red LEd (12) will light up.
6. Switching on the board bar:
Cooling: Set the switch (8) to the "CoLd" position.
heating: Set the switch (8) to the "hoT" position.
7. The board bar will start cooling/heating. The LEd will light up green (7 - cooling) or
red (5 - heating).
attention: There is no auto shut-off. The unit will run continuously so long as the board
bar is switched on. remember the vehicle's battery will be discharged when the
vehicle is not running.
8. Set the switch (8) to the "oFF" position to stop cooling/heating.
9. Unplug the 230 V mains plug (11) from the mains socket or the car plug (14) from
the 12 V car outlet and neatly roll up the cable.
10. Clean and dry the inside of the board bar after use. This will prevent mould from
forming.

Tips for achieving the best cooling power

▪
Select a well ventilated location for use, away from sunlight.
▪
allow warm dishes to first cool down before keeping them cool in the board bar.
▪
do not open the board bar more than necessary.
▪
do not leave the board bar open longer than necessary.
GB
21