Car-O-Liner CMI 3000 II Kurzanleitung Seite 5

Standard control panel MIG/MMA
16
10
7
11 6
8
12
9
13 4 5
14 2
1
15
3
10
17
9
7
1
2
1 Setting welding current
Turn the control knob to set the desired
welding current.
2 Display of welding current
3 Display of transfer area:
- dip transfer
- globular transfer (risk of weld spatter)
- spray transfer
4 Display of wire feed speed
5 Display of material thickness
6 Setting welding voltage
Turn the control knob to trim/set the desired
welding voltage
7 Display of welding voltage
8 Display of +/- voltage trim
9 Display of selected program/job
10 Menu
11 Display of present
sequence/sequences in total
Press key to change to next sequence.
12 Pulse welding
MIG pulse welding on/off.
13 Tack welding
When this function is activated, sequence,
hotstart and slope down are off.
14 DUO Plus
TM
Pulsating wire in connection with synergic
MIG on/off
15 Selecting trigger mode
Change between 2-stroke (indicator is black)
and 4-stroke (indicator is green).
2-stroke: the welding process starts when
the torch trigger is activated and ends when
the torch trigger is released.
4-stroke: the welding process starts when
the torch trigger is activated and released
(hotstart is active until release of torch
trigger) and ends when the torch trigger is
activated again.
16 Symbol for active wire feed unit
i = internal wire feed unit
1 -> = external wire feed unit(s)
17 Symbol for MMA
50113795
QUICKGUIDE CMI 3000 II
Setting welding process MIG/MMA-
Process setup
14
6
5 7
8
15
2
4 9
3 12 10 11
16
13
17
18 1
14
19
6
2
5
13
1
1 Setting parameters
Turn the control knob to set the desired
parameter value
2 Selecting welding parameter
Turn the control knob to select the desired
welding parameter
3 Pre-gas (sec.)
4 Softstart (m/min)
UK
5 Hotstart (%)
6 Hotstart time (sec.)
7 Slope down (sec.)
8 Stop amp time (sec.)
9 Stop amp (%)
10 Burn-back (1-15)
11 Post-gas (sec.)
12 Spot time (sec.)
13 Set current
14 Home/return
Short pressure on (14) = return to menu.
Long pressure on (14) = return to standard
control panel
15 Present sequence/sequences
in total
16 Arc adjust
17 Pulse
MIG pulse welding on/off
18 Gas
Gastest. Setting manuel gas/IGC (not all
versions)
19 Arc Power (%)
page 1 of 4