Werbung
h. To start communication between the terminal and the Modbus device, click "Add
new device".
i.
Enter a name for the device and select the type of the device from the drop-down
box. To add new device types, see www.youtube.com/watch?v=99dj4PDMwQQ
below. Set the Modbus address of the connected device.
j.
Click "Add". CoT will now send a notification to the SMARTbox that a new device is
ready to be managed. This may take a few seconds.
Use the built-in Location and Tracking functionality (>2.3.x)
____________
The terminal features cell location and is available in Location tab on terminal level.
Devices are shown as "pins" that you can click to see the name of the device. Clicking the
name of the device takes you to the detailed view of the device. You have 3 Options:
1.
Using the built in Cell Location. The terminal identifies 3 cells in the near
environment and derives the location (default)
2. Using the hardware Option with a built in- GPS (this is an extra option). Set
c8y.GPS=1 then GPS is enabled. Setting c8y.GPS=0 Cell location is enabled (default)
3. Activate a regular identification of the location. In Configuration tab you can set:
c8y.LocationCycle=60; define in min, how often the location should be checked. 0
means the cycled checking is disabled. If a value >0 ist set, also the tracking is
enabled
PSsystec SMARTbox IO Agent User Guide
8
Werbung
