Grizzly EKS 2440 QT Betriebsanleitung Seite 125

use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less Iikely to
bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions
and the work to be performed. Use
of the power tool for operations differ-
ent from those intended could result in
a hazardous situation.
h) If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
5) SERVICE
a) Have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
6) CHAIN SAW SAFETY WARNINGS:
Keep all parts of the body away from
a)
the saw chain when the chain saw is
operating. Before you start the chain
saw, make sure the saw chain is not
contacting anything. A moment of
inattention white operating chain saws
may cause entanglement of your cloth-
ing or body with the saw chain.
b) Always hold the chain saw with
your right hand on the rear handle
and your left hand on the front
handle. Holding the chain saw with a
reversed hand configuration increases
the risk of personal injury and should
never be done.
Wear safety glasses and hear-
c)
ing protection. Further protective
equipment for head, hands, legs
and feet is recommended. Adequate
protective clothing will reduce person-
al injury by flying debris or accidentaI
contact with the saw
d) Do not operate a chain saw in a
tree. Operation of a chain saw white
up in a tree may result in personal in
jury.
e) Always keep proper footing and
operate the chain saw only when
standing on fixed, secure and level
surface. Slippery or unstable surfaces
such as ladders may cause a loss of
balance or control of the chain saw.
f) When cutting a Iimb that is under
tension be alert for spring back.
When the tension in the wood fibres is
released the spring loaded Iimb may
strike the operator and/or throw the
chain saw out of control.
Use extreme caution when cutting
g)
brush and saplings. The slender
material may catch the saw chain and
be whipped toward you or pull you off
balance.
h) Carry the chain saw by the front
handle with the chain saw switched
off and away from your body. When
transporting or storing the chain
saw always fit the guide bar cover.
Proper handling of the chain saw will
reduce the Iikelihood of accidentaI
contact with the moving saw chain.
Follow instructions for lubricating,
i)
chain tensioning and changing ac-
cessories.
Improperly tensioned or lubricated
chain may either break or increase the
chance for kickback.
Keep handles dry, clean, and free
k)
GB
chain.
125